Search found 66 matches

by fredcamp2
Fri Jan 12, 2018 9:10 pm
Forum: Problems / Questions
Topic: ***Fixed*** Wipers don't work, have checked all the usual stuff.
Replies: 22
Views: 43696

Re: Wipers don't work, have checked all the usual stuff.

Front wipers. The upc (engine bay fusebox) receives the wiping requests from the uch via the multiplex network the computer then controls the following requests. Low or high speed windscreen wipers . Windscreen wiper park position. windscreen high & low speed are both fed via connector pph2 brow...
by fredcamp2
Sun Jan 07, 2018 6:56 pm
Forum: Problems / Questions
Topic: Rad fan
Replies: 2
Views: 1938

Re: Rad fan

What makes you suspect your cooling fan is faulty. To check the system when vehicle is sitting stationary start engine let it sit there idling it will soon reach running temperature then it will soon reach boiling point but just before boiling point your cooling fan has to activate if not then the s...
by fredcamp2
Wed Dec 27, 2017 10:19 pm
Forum: Problems / Questions
Topic: Won't stay running until warm, help!
Replies: 3
Views: 2635

Re: Won't stay running until warm, help!

I would be much more inclined to think your dtc's are red herrings the oxy sensors on your vehicle has a 4 terminal plug 2 white heater wires 1 must have a 12v feed at key on the other 1 goes back to the ecu the other 2 wires 1 grey signal wire to the ecu & 1black earth wire. I would get the thr...
by fredcamp2
Sun Dec 17, 2017 7:29 pm
Forum: Problems / Questions
Topic: New clutch starting issue
Replies: 4
Views: 2703

Re: New clutch starting issue

When you first turn the start key or push button on your car your fuel pump runs for a few seconds to prime the system to aid easier starting then it stops pumping but when engine is running the ecu switches the fuel on again (engine running) Your car is only running that few seconds using the small...
by fredcamp2
Sun Dec 17, 2017 6:53 pm
Forum: Problems / Questions
Topic: Megane mk2 noise
Replies: 7
Views: 3921

Re: Megane mk2 noise

Differental problem which means replacement of gearbox 100%
by fredcamp2
Wed Nov 22, 2017 7:59 pm
Forum: Problems / Questions
Topic: The dreaded STOP light and alarm issue
Replies: 3
Views: 4315

Re: The dreaded STOP light and alarm issue

The brake light switch double switch for brake lights & it operates as a safety device in the event of a problem with the accelerator position sensor. to check this out if the brake pedal is depressed while the accelerator at a constant at a constant position (engine running ) the engine speed s...
by fredcamp2
Fri Mar 31, 2017 7:45 pm
Forum: Problems / Questions
Topic: Cause of Misfire?
Replies: 33
Views: 31246

Re: Cause of Misfire?

Owing to the high energy coils fitted to these Renaults it's imperative that the proper recommended spark plugs are fitted. Do not lightly dismiss the the the wiring from coil 1 & coil 2 straight through to the ecu corresponding pin no's. Can you post up your engine code starts with k4m ??? what...
by fredcamp2
Thu Mar 30, 2017 8:31 pm
Forum: Problems / Questions
Topic: Cause of Misfire?
Replies: 33
Views: 31246

Re: Cause of Misfire?

Misfiring covers a multitude of problems. Imbalance between cylinders. Sticking valves. Wiring from no 1 coil to no 4 straight through to correstp0nding ecu pin no's. the same check at coil 2 to coil 3 to corresponding ecu pin no's. A manifold vacuum test will tell you a lot. What I would recommend ...
by fredcamp2
Tue Feb 21, 2017 9:36 pm
Forum: Problems / Questions
Topic: Start up and idle issues
Replies: 2
Views: 2252

Re: Start up and idle issues

The 4 aeras this needs to be checked out
coolant temp sensor
air intake temp sensor
throttle body control
ensure timing set correctly
by fredcamp2
Mon Feb 20, 2017 7:55 pm
Forum: Problems / Questions
Topic: injector fault - error df053 1.5 dci 2005
Replies: 5
Views: 27210

Re: injector fault - error df053 1.5 dci 2005

The 64 dollar question is how does your car start when it reaches running temperature. the hand primer pump on these Renaults do not go hard when the system is primed.
by fredcamp2
Tue Jun 21, 2016 7:10 am
Forum: Problems / Questions
Topic: Scenic won't start!
Replies: 2
Views: 2067

Re: Scenic won't start!

1 of the things you do not do when a vehicle is a non starter is starting to throw bits at it 70% of faults on these are down to wiring problems not components. If the fuel pressure regulator which sits on the rear of the high pressure pump is not being driven by the ecu then you do not have any rai...
by fredcamp2
Tue Feb 16, 2016 11:44 pm
Forum: Problems / Questions
Topic: Megane Extreme 16V Wont start
Replies: 2
Views: 2061

Re: Megane Extreme 16V Wont start

On these the starter relay is incorporated into the engine bay fusebox this fusebox also has a 25amp starter fuse marked fuse 3
by fredcamp2
Fri Jan 15, 2016 8:39 pm
Forum: Problems / Questions
Topic: 2003 megane 1.4 check injection,fault code p0638 strange
Replies: 6
Views: 5887

Re: 2003 megane 1.4 check injection,fault code p0638 strange

The fault code your getting could be a red herring depending what it was read with po 638 throttle control motor with position sensor this code relates to a fault outside the unit it's self either not getting it's 2 power feeds via the ecu 1x12v feed via ecu pin no am3 to multi-plug marked terminal ...
by fredcamp2
Thu Aug 13, 2015 9:05 pm
Forum: Problems / Questions
Topic: Sluggish Megane 1.9 dci
Replies: 4
Views: 2736

Re: Sluggish Megane 1.9 dci

Get the innards of your turbo vanes checked & cleaned which requires turbo strip down to cure your problem (common problem) on these dci's
by fredcamp2
Thu Jun 11, 2015 9:26 pm
Forum: Problems / Questions
Topic: 52 plate megane not starting
Replies: 1
Views: 1906

Re: 52 plate megane not starting

Lets just say the best place (bar none) to check out a crankshaft sensor is at the ecm unit. The engine bay fusebox (upc) on these the fuel pump relay & the main engine control relay are incorporated into this fuse box between them they supply the 5 x 12v feeds to the ecm pin no's ??? Posting up...

Go to advanced search