The Mégane II Owners' Club

Hi guys,

Replaced the battery in the GT220 , now the following code comes up. Other code cleared ok but the clutch position sensor error. Only appeared after the battery was changed. Any ideas?

Thanks

Do you have stop/start and do you use it? If its been disabled then you might not realise the switch on the clutch pedal is faulty or a wire has broken. That's where I would look first. Sometimes a high resistance in the circuit can also throw a fault, so disconnect the connectors to the switch and reconnect a few times to clean them up a bit and see what happens. Its worked for me on other DTC sensor faults related to switches.

Candleman